Siedziba firmy:
K&K PRODUCTS
ul. Leśnianka 62, 34-300 Żywiec
NIP: 553-239-24-40, REGON: 240701975

Skontaktuj się z nami:
tel.: 0048 33 474 09 45
fax: 0048 33 861 11 43
e-mail: biuro@k-k-p.pl

Assembly, connection diagram



We recommend impulse transformers for power supply of glass blocks. The glass blocks supply voltage must not exceed 12,5VDC. For connection of glass blocks we recommend single LgY copper cables (cablet type), P.V.C. insulated, size 1,5mm2; the outer diameter of cable insulation must not exceed 3,5mm. The best way to mark the supply polarization is using color cables – for ex ample red cable (+) and black cable (-). The glass block voltage polarization has been marked with colors: red (+) and black (-). End of supply circuit (ends of transformer cables) has to be protected against humidity with insulation tape (best self-vulcanizing) – you should not build a loop for this circuit, i.e. the cable ends should not be connected back to the transformer. The glass blocks are connected with type Scotchlok 804 connectors, according to the manual attached to the connectors. While laying cables in the seam between the glass blocks you must not stretch them – they should lie freely. The connection should be carried out with power supply switched off. After connection of each glass block and before pouring mortar over it, the power supply has to be switched on in order to check if the connection has been carried out properly and if the glass block functions correctly (the glass block should shine). After everything has been checked and works correctly, the cables in the seam should be laid and the connectors placed between the corners of glass blocks.